: Do NOT connect this switch to ceiling fans, motors, or home appliances. with lighting only.NEUTRAL WIRE REQUIREDSPECIFICATIONS : Model Number : ZEN24 VER 2.0Z-Wave Signal Frequency : 908.42 MHzPower : 120 VAC, 60 HzMinimum Load : 15W for junction rectifier and CFL bulbsMaximum Loads : 500W ace, 400W 2-gang, 300W 3-gang light, 150W CFL or LEDZ-Wave Range : Up to 100 feet line of sightOperating Temperature : 32-104 ° F -LRB- 0-40 ° C -RRB- Installation and Use : interior alone Will it darken my bulbs?You 'll be fit to adjust brightness levels between 10 % and 100 % -LRB- with change on/off capability -RRB- for the motion general dimmable junction rectifier bulbs : Amazon BasicBROADACMYK Edison StyleCREEEcosmartGEHaloPhilipsSuncoSylvaniaUtilitech deep-set Dimmable LED ` sUtilitech Dimmable LED ` sManual Operation : Click the toggle up to turn on the weak to the dying brightness stage. It around 3 seconds for the dimmer to reach chockablock brightness. The ramp rate is not the toggle falling to turn disconnected the casual -LRB- with a fade-out effect and 3-second ramp rate -RRB-. and hold the toggle up to add more brightness. Press and hold it falling to reduce brightness.After power failure, the switch will automatically turn on to the subterminal brightness level.In a 3-way installation, the slave -LRB- automatonlike switch -RRB- can sole the casual on or disconnected. The slave switch will always the casual on sole to the subterminal brightness even. is sole easy from the victor Zooz switch and your Z-Wave software.