SURFACE rise INSTALLATIONStep1 -RRB- to installation. Please two screws -LRB- provided with -RRB- into the junction box. Not drive screws completely to the end of the junction box.Step2 -RRB- Connect supply wires to wires in fixture wiring box with kosher size wire nuts or push wires into `` push-in '' connexion. Connect livid to livid, bootleg to bootleg, and spectral colour or unsheathed copper wire to unsheathed copper wire.Step3 -RRB- The priming coat wire at the service junction box may need to be secured to a priming coat screw.Step4 -RRB- With a Phillips screwdriver, the disk gentle tightly to the j-box. Step5 -RRB- hearty the by twisting the diffuser on the disk gentle aluminum enclosure and lock up the diffuser in place. Step6 -RRB- The of the fixture and the ceiling use tight silicone to seal.WARNING : For your safety read and understand instructions completely before staring instructions. Before wiring to power supply, unsatisfactory electricity at the fuse or circuit breaker box .1. Risk of FireSupply conductors -LRB- power wires -RRB- connecting the fixture must be lowest 90 ?. If hesitant, consult an electrician2.Risk Of Electric ShockDisconnect power at fuse or circuit breaker before installing or servicing3.Risk Of Fire/Electric ShockIf not qualified , an electricianCAUTIONTHIS PRODUCT necessity BE INSTALLED IN ACCORDACE WITH THE relevant INSTALLATION CODE BY A PERSON long-familiar WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED .